Thursday, November 3, 2016

Enable DSCP Markings on Windows OS (7, 8, 10)

By default windows OS will set DSCP markings to '0' ignoring the marking settings on the client. This can be good and bad.

A good scenario is to make sure that torrent clients aren't getting priority (while ideally your enterprise network qos policies should overcome this problem as well)

A bad scenario is overriding DSCP markings from Jabber Client which marks packets genuinely  for seperating audio and video streams treatment.

While you can still overcome the problem of Jabber Client using network QoS policies, you can allow QoS marking on windows OS as follow:

1. Go to HKLM\System\CurrentControlSet\Services\Tcpip\QoS. If "QoS" folder doesn't exist there - create it.
2. Add a DWORD parameter named "Do not use NLA" and assign "1" as its value.
3. Reboot.



at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

DNS Performance Troubleshooting

When you are troubleshooting internet performance, there are different parts of the connection should be verified:   ·         DNS Pe...

  • PxGrid Part # 3 - Troubleshooting FMC-ISE Identity Sync
    From FMC CLI, verify ISE integration status using the command   root@vFPMC:/etc/rc.d# cat /var/sf/run/adi-health $status = {      'ADI&#...
  • Enable ISE SSH Access
    If you missed enabling SSH access during the initial setup of ISE, you can enable it using console by pasting the command   service sshd enable
  • CUCM SIP Early Offer
    By default CUCM uses SIP Delayed Offer. In order to enable Early Offer, use one of the following methods: MTP is required ...