Prior to CUCM 9.0
In CUCM codec
selection is based on regions. CUCM will check the regions for originating and
destination endpoints and, accordingly, allocate the configure
inter-region/intra-region codec.
CUCM will apply the
codec based on Max Audio Bit Rate. It
won't select specific codec (e.g. G.711 or G.729). For example, if the max audio bit rate configured is 64 kbps (G.722, G.711) & advertise G.722 Codec enterprise parameter is enabled, CUCM will advertise G.722 for this
call. If the enterprise service parameter is disabled, CUCM will advertise
G.711. CUCM will never advertise G729 for this call,
although it has bit rate of 8kbps which is lower than configured max audio bit rate, even if it requested by the other party (in this case
xcoder will be deployed or call will fail).
In
Summary CUCM codec selection is based on Best
Quality which fits within the configure Max
Audio Bit Rate.
Note: Within G711 you can choose
between alaw or ulaw by changing the service parameters G.711 A-Law
Codec Enabled & G.711 Mu-Law
Enabled. You can
also change this on SIP trunk if MTP is selected by changing the parameter MTP Preferred
Originating Codec.
CUCM 9.0+
New parameter has
been introduced which is Audio Codec Preference
Lists. The Maximum Audio Bit rate
is still applied for calls within a region and between regions, but rather that
using the highest audio quality codec; the codec selection is now made based on
the codec order in the Audio Codec Preference List and the codecs that the
endpoints support.
To configure this
feature:
- Create new Audio Codec Preference List by navigating to Cisco Unified CM Administration > System > Region Information > Audio Codec Preference List.
Note: Codecs cannot be removed
from the Audio Codec Preference List. You can change the order only
- Assign the list to your inter-region/intra-region configuration
During call setup,
CUCM will check the list of supported codecs by endpoint and audio codec
preference list. Accordingly, CUCM will advertise the overlapping codecs in its
call setup which fulfill max audio bit rate requirement.
Example#1
Example#2
Note: When configuring ICT trunk
between CUCM clusters, it is very important that both clusters should have
mirrored Audio Codec Preference Lists and Inter-Region/Intra-Region configuration.
In deployments where
calls can pass through more than one CUCM cluster, for example SME deployments;
the inter-region Audio Codec Preference List of the intermediary CUCM cluster
can over-ride the preferred codec selection between the calling and called device.
To ensure that the endpoints’ codec preferences are honored as calls pass
through SME, enable the SIP Profile feature “Accept
Audio Codec Preferences in Received Offer” on all SME SIP Trunks
No comments:
Post a Comment